How to Perform Calibration on Eizo Medical Display Monitors Using Eizo RadiCS DICOM Calibration and QA Software - Win 10 Pro


You need to perform a DICOM calibration on your Eizo Radiforce medicaid display monitors.


Follow the instructions below to calibrate your Eizo monitors using RadiCS v5. Please contact us to request a copy of the Eizo calibration and QA software if you need a copy. Please follow the instructions on how to install the Eizo RadiCS calibration software if you do not have a copy installed on your system.

Before you start, please make sure that your USB Type-B cable is connected from

your monitors to your computer.


Open RadiCS Version 5


Wait for RadiCS to detect monitor(s)



Click on Administrator mode


Type password: passwordv5. Click OK


Click Calibration


Verify the monitors are selected. Click Proceed


During the calibration process, the RadiCS software will fade out


Also, during the calibration, the monitor(s) will go black and the build-in sensor will pop out.


On the Finish page, click on Passed or Failed to view a detailed report


Click Finish


Your monitor(s) will now be calibrated to the DICOM standard. If you wish to configure RadiCSv5 to automatically calibrate your monitors, please follow the How to Schedule Automatic Calibration in Eizo RadiCS DICOM Calibration and QA Software v5 - Win 10 Pro guide.


Leave a comment

All comments are moderated before being published

Featured Products

Save $1,826
Eizo RadiForce MX315W 8MP 31" Color Clinical Review Display Monitor (MX315W-BK)
Save $200
Eizo Radiforce RX340 3MP 21" Color LED General Radiology Diagnostic PACS Display (RX340-BK)
Save $3,000 Save $3,000
Eizo RadiForce RX560 5MP 21" Color LED Mammo 3D-DBT Breast Imaging Display (RX560-BK)